Kubota M4N-071, Руководство оператора

Страница: 85 / 152

(1) Turnbuckle
(2) Set-pin (3) Hex wrench handle
(4) Stabilizer
7.1 Turnbuckle unlocked position
1. Lift the set-pin and slide the hex wrench handle
forward.
(1) Set-pin
(2) Hex wrench handle
(A) “Lift” (B) “Slide forward”
2. Lower the set-pin and make sure the hex wrench
handle cannot move past the set-pin tip.
(1) Set-pin (2) Hex wrench handle
7.2 Rotating the turnbuckle
1. Use the hexagonal part of the wrench and the hex
wrench handle to rotate the turnbuckle once.
2. Slide the hex wrench handle forward to release it
from the turnbuckle.
3. Rotate the hex wrench handle and slide it backward
until the hexagonal part is locked on the turnbuckle.
4. Repeat steps 1 to 3 until the desired stabilizer
length is achieved.
Rotating Stabilizer length Lower link width
clockwise Shorten Widen
Counterclockwise Lengthen Narrow
Example: turnbuckle (RH) counterclockwise
(1) Hexagonal part
(2) Turnbuckle
(3) Hex wrench handle
(A) “Rotate” (B) “Slide forward”
(C) “Slide backward”
NOTE :
• Adjusting the left hand side stabilizer is
done the same way as for the right hand
side stabilizer.
DRAWBAR
WARNING
To avoid personal injury or death:
THE 3-POINT HITCH SETUP 3-POINT HITCH AND DRAWBAR
M4N-071, M5N-091, M5N-111
79