Kubota KX61-3, Руководство по эксплуатации

Страница: 104 / 138

Maintenance
104
•
Install a new return filter (1) in the filter support (2).
•
Insert the filter support with return filter into the hydraulic oil
tank through the return pipe.
•
Check the condition of the sealing ring on the tank cap.
Replace it if necessary.
•
Install the tank cap (1) with the guide pin into the filter sup-
port (2) and tighten it.
•
Close the side cover.
Replacing the suction filter in the hydraulic oil tank
Pay attention to utmost cleanliness when servicing
the hydraulic system.
This service may only be carried out after the hy-
draulic oil has cooled down.
The suction filter must be replaced along with the
hydraulic oil.
•
Drain the hydraulic oil (page 105).
•
Remove the return filter from the hydraulic oil tank (page 103).
•
Screw off the suction filter (figure above, position 1).
•
If necessary, remove any residues with a clean, lint-free cloth.
Discard the suction filter and cleaning cloth in accordance with applicable environmental protec-
tion regulations.