REGULAR CHECKS AND MAINTENANCE WORK
22
EN
GLISH
A
Make sure the hooking clip for the element is tight
enough. If it is loose, dust and dirt may be sucked in,
wearing down the cylinder liner and piston ring earlier
and thereby resulting in poor power output.
A
Do not overservice the air cleaner element.
Overservicing may cause dirt to enter the engine
causing premature wear. Use the dust indicator as a
guide on when to service.
C
Cleaning primary air cleaner element
1. To clean the element, use clean dry compressed air
on the inside of the element.
Air pressure at the nozzle must not exceed 205 kPa
(2.1kgf/cm , 30psi).
Maintain reasonable distance between the nozzle and
the filter.
B
Adjustment of fan belt tension
[V2607-CR-TIE4, V3307-CR-TIE4, V3800-TIE4]
To avoid personal injury or death:
A
Be sure to stop the engine and
remove the key before checking the
belt tension.
A
Be sure to reinstall the detached
safety shield after maintenance or
checking.
1. Stop the engine and remove the key.
2. Apply moderate thumb pressure to belt between the
pulleys.
3. If tension is incorrect, loosen the alternator mounting
bolts and, using a lever placed between the alternator
and the engine block, pull the alternator out until the
deflection of the belt falls within acceptable limits.
4. Replace fan belt if it is damaged.
A
If belt is loosen or damaged and the fan is damaged,
it could result in overheats or insufficient charging.
Correct or replace belt.
[V2607-CR-TIE4, V3307-CR-TIE4]
[V3800-TIE4]
(1) Air cleaner body
(2) Dust cup
(3) Secondary element
(4) Primary element
(5) Evacuator valve
Proper fan belt
tension
A deflection (A) when the belt is
pressed in the middle of the span.
Models
(A)
V2607-CR-TIE4
V3307-CR-TIE4
10 to 12 mm (0.39 to 0.47 in.)
(under load of 10 kgf (22.1 lbs))
V3800-TIE4
10 to 12 mm (0.39 to 0.47 in.)
(under load of 6 to 7 kgf
(13.2 to 15.4 lbs))
(1) Fan belt
(2) Bolt and nut
(1) Fan belt
(2) Bolt and nut
1J778-8915_E.book 22 ページ ２０１６年６月２０日 月曜日 午後５時７分
