Kubota AP-SC7072, Руководство оператора

Страница: 14 / 36

Section 1: Assembly & Set-up
Table of Contents
AP-SC7072 Skid Cutter 326-974MK 2/6/19
10
Hydraulic Hose Hook-Up
Refer to Figure 1-1 on page 8:
WARNING
!
To avoid serious injury or death:
•
Shut power machine down and release all hydraulic
pressure to the equipment before connecting or
disconnecting hydraulic hoses to or from the power
machine.
•
Hydraulic fluid under high pressure can penetrate the skin
and/or eyes causing a serious injury. Wear protective gloves
and safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood rather than
hands when searching for leaks. A doctor familiar with this
type of injury must treat the injury within a few hours or
gangrene may result. DO NOT DELAY.
.
Refer to Figure 1-5:
1. If attaching to a Kubota SVL machine, be sure to
route hydraulic hoses through hose loop (#1) on the
left side of the cutter hitch as shown.
Hose Route For Kubota SVL Machine
Figure 1-5
Refer to Figure 1-1 on page 8:
2. Thread hoses through any hose holders that may be
helpful on the machine operating the cutter. See your
skid steer Operator’s Manual for instruction on how to
use these hose holders.
IMPORTANT: The customer must select best way to
route the hydraulic hoses. Make sure the hoses will
not contact the skid steer wheels or tracks. See
“Equipment Clearances” on page 13
for detailed instructions on how to check for
clearances.
NOTE: Use of Kubota’s SVL Hose Stay is not
recommended for this attachment.
70030
1
Do Not Use
SVL Hose Stay
3. Connect male and female couplers on the cutter to
the appropriate skid steer flat faced couplers.
4. Operate skid steer to check blade rotation. The SC70
is designed to have cutter blades rotate clockwise
when looking down at the deck.
5. Zip tie hydraulic hoses together every 2 feet from
male and female couplers.