Kubota 21400001, Руководство пользователя

Страница: 15 / 44

ASSEMBLY
OM 0427SB-A [12]
1. Hydraulic hose
2. Cardboard
3. Magnifying glass
I
NSTALLATION WITH THE AUTO
-
CONNECT COMPLETION KIT
L4432
Refer to the Instruction sheet provided with the L4432 Completion kit
I
NSTALLATION WITH THE MANUAL COMPLETION KIT
- L4431
Hydraulic Hoses Installation
(Fig.3-3a)
1. Figure 3: On each hydraulic hose (item 3)
insert a protective nylon sheath (item 4). The
protective nylon sheath should cover the hose
from the male fitting of the hose.
2. Figure 3: Install a nylon tie wrap (item 5) in the
middle of the protective nylon sheath (item 4).
3. Figure 3: On each hydraulic hose apply thread
sealant onto the male fitting. Install female
quick coupler (item 6), dust cap (item 7) and
identification rings (item 8-9). Install both set of
identification ring on the hose one will be
removed later for the identification of the
coupler on the tractor valve.
4. Figure 3: Install both flow restrictors (item 1)
into the port of the hydraulic motor (item 2).
5. Figure 3: Install the hydraulic hoses (item 3) to
the flow restrictors (item 1) on the motor
(item 2).
6. Figure 3a: Install the hose support (item 1) on
the upper corner of the 4-point hitch with a
3/8"NC x 1 1/4" bolt, 3/8" (7/16" hole) flat
washer, 3/8" lockwasher and 3/8"NC nylon
insert locknut (items 2 to 5). Before tightening,
run the hoses inside the hose support and
direct the hose support so that hoses move
freely. Then tighten the bolt firmly.
WARNING: To avoid serious
personal injury.
Escaping hydraulic/
diesel fluid under pressure can penetrate
the skin causing serious injury
.
•
Do not use your hands to
check for leaks. Use a
piece
of cardboard or
paper to search for leaks.
•
Stop engine and relieve pressure before
connecting or disconnecting lines.
•
Tighten all connections before starting
engine or pressurizing lines.
•
If any fluid is injected into the skin, obtain
medical attention immediately or
gangrene may result.
Figure 3a Figure 3