Kübler CODIX 555, Руководство пользователя, Страница: 42 / 124

Page 10 www.kuebler.com
55 P Pa arra am me ette err sse ettu up p
The parameters have to be set up before
putting the unit into operation.
–
– IIn np pu utt p pa arra am me ette err
The parameters of the scaling slope must
be set up depending on the sensor used.
–
– S Sc ca alliin ng g ssc co op pe e
The correspondence between the input
signal and the displayed value is given by
the scaling slope. The scaling slope is set
up by entering pairs of values.
–
– T To otta alliizze err
The decimal point, the factor of the meas-
uring unit, and the scaling of displaying
the total value calculated by the unit must
be set up.
– – A Alla arrm mss//o ou uttp pu uttss
Either none, one or two alarm values can
be active. Hysteresis and output parame-
ters are also set up. If the set-point is ex-
ceeded, a signal will be sent out at the
corresponding output and the correspon-
ding LED will be switched on.
The alarms themselve are set up in the
operating mode!
–
– M Ma aiin nss H Hu um m FFiilltte err
To reduce operational interference
caused by the 50/60 Hz mains supply you
can choose the local mains frequency.
55..11 P Pa arra am me ette err M Mo od de e
To put the unit into set-up mode
1. keep the
key pressed
2. connect the unit with the power supply
3. When the display shows
release the key.
G Ge ettttiin ng g a ac cq qu ua aiin ntte ed d w wiitth h tth he e d diissp plla ayyss a an nd d
kke eyyss
The selection or the settings can be run
through as often as required thanks to the
step-through programming method
M
Me en nu u iitte em m::
The display alternates every 2 seconds
between
E En ntte erriin ng g iin ntto o tth he e m me en nu u::
Either a selection has to be made or a
value has to be set up.
Press the
key . The display stops
alternating.
–
– M Ma akkiin ng g a a sse elle ec cttiio on n::
Pressing the key displays all the pos-
sible settings one after the other.
–
– E En ntte err tth he e sse elle ec cttiio on n::
Press the key. The selected param-
eter will be stored. The next menu item
appears
–
– E En ntte erriin ng g a a vva allu ue e::
The flashing digit indicates that it is en-
abled for entry.
Press the
key, the number will be
incremented.
Menu <–> Selection