Kübler CODIX 52T, Руководство по эксплуатации

Страница: 9 / 32

5. Technical data
Supply voltage
Power supply: 10 ... 30 V DC/max. 55 mA
with inverse-polarity pro-
tection
Display: 6 digits, red 7 segment
LED display, height 8 mm
Data retention: EEPROM
Polarity of the inputs:
Programmable, npn or pnp
for all inputs
Input resistance: appr. 5 k
⍀
Count frequency:
DC power supply:
24 V 12 V 10 ...30 V
Input level: Standard 5V
typ. low level: 2,5 V 2,0 V 1,0 V
typ. ligh level: 22,0 V 10 V 4,0 V
Fmax:* kHz kHz kHz
tot.tot 60 20 8
* at maximum frequency square wave pulses 1:1
Minimum pulse length for the Reset input:
5 ms
Input sensitivity:
Standard sensitivity:
Low: 0 ... 0,2 x U
B
[V DC]
High: 0,6 x U
B
... 30 [V DC]
4 ... 30 V DC level: Low: 0 ... 2 V DC
High: 4 ...30 V DC
3
e
n
g
lis
h
-
S
u
b
je
c
t
to
c
h
a
n
g
e
w
it
h
o
u
t
p
ri
o
r
n
o
ti
c
e
-
It can be set from 00.0001 up
to 99.9999.
The decimal point is set to 4
decimal places. „0“ is not
accepted!
4.7 Multiplying factor (totaliser 2)
It can be set from 00.0001 up
to 99.9999.
The decimal point is set to 4
decimal places. „0“ is not
accepted!
4.8 Dividing factor (totaliser 2)
The decimal point defines the
way of displaying the count val-
ues. It does not affect counting.
0 no decimal place
0.0 one decimal place
0.00 two decimal places
0.000 three decimal places
4.9 Decimal point (totaliser 2)
5.0 RESET Mode (totaliser 2)
manual reset via the red
RESET key and electrical reset
via the RESET input
no reset (red RESET key and
RESET input locked)
only electrical reset via the
RESET input
only manual reset via the red
RESET key
5.1 End of programming
The programming routine is
repeated once more. The val-
ues set until now can be
checked and modified.
The programming routine wil be
left and all values set will be
stored as new parameters.
Afterwards the device is ready
for operation.