SYNTEX
®
-NC
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
46110 EN
11 of 23
4
Please observe protection
note ISO 16016.
Drawn:
2017-02-10 Pz/Koh
Replacing:
KTR-N dated 2014-08-11
Verified:
2017-03-03 Pz
Replaced by:
Clean the hub bore and shaft and review for dimensional
accuracy, afterwards lubricate with a thin-fluid oil (e. g. Castrol
4 in 1 or Klüber Quietsch-Ex).
Illustration 10: axial locking
!
Oils and greases containing molybdenum disulfide
or other high-pressure additives as well as internal
lubricants must not be used.
Mount the SYNTEX
®
-NC (component assembly 1) on the shaft of
the driving or driven side.
Please provide for an end plate to fasten the SYNTEX
®
-NC axially
(see illustration 9).
We recommend to secure all screw connections against working loose additionally,
e. g. conglutinating with Loctite (average strength).
With the use of hollow shafts please observe chapter 4.6 before assembly of SYNTEX
®
-NC.
Unscrew the clamping screw (component 2.10) in the clamping
ring (component 2.9).
Clean the hub bore and shaft and review for dimensional
accuracy, afterwards lubricate with a thin-fluid oil (e. g. Castrol
4 in 1 or Klüber Quietsch-Ex).
Illustration 11: Assembly of SYNTEX
®
-NC
(hub design 6.1)
!
Oils and greases containing molybdenum disulfide
or other high-pressure additives as well as internal
lubricants must not be used.
Mount the SYNTEX
®
-NC (component assembly 2) on the shaft of
the driving or driven side.
Tighten the clamping screw to the tightening torque T
A
specified in
table 2.
If the assembly is repeated the bore of the hub and shaft have to be cleaned and afterwards
lubricated with a thin-fluid oil (e. g. Castrol 4 in 1 or Klüber Quietsch-Ex).
All screw connections must be secured against working loose additionally, e. g.
conglutinating with Loctite (average strength).
4
Assembly
4.4 Assembly of SYNTEX
®
-NC (hub design 1.0)
4.5 Assembly of SYNTEX
®
-NC (hub design 6.1)
