Declaration of conformity
Safety devices
Only work on the screw capping machine when the safety devices are fitted
and functioning correctly.
1. Guard on screw capping machine
Plexiglas guard over capping unit. The control system immediately shuts off
the screw capping machine when the guard is pulled up.
The screw capping machine cannot be switched on if the guard is up.
2. Panels fitted to machine frame
The machine frame panels serve to protect against accidental contact with
sharp-edged metallic parts and moving belt drive components during
operation. Only start up the screw capping machine when the panels are
fixed in position.
Intended use
This screw capping machine is used to seal off bottles with screw caps. The
bottles are fed in using a belt drive system, the caps are automatically picked
up. The screw head presses the cap onto the bottle. The screw head then
knurls the thread into the cap. After the bottle is sealed, it is transported
away by the belt drive.
For the environment
Dispose of the condensation from the pneumatic water separator in an
environmentally-friendly manner.
Safe transportation
The TV 2000 screw capping machine may be transported using a fork-lift
truck or overhead crane.
•
Two lifting eyes are provided at the top of the TV 2000 (see main diagram
page 5, position 2). These may be used to attach a lifting rope using a
rope shackle or carabiner. The TV 2000 can then be transported using a
crane or on the lifting fork of a fork-lift truck.
•
The TV2000 can be laid on its back (rear doors) if it is being transported
by HGV or trailer.
The screw cap container can be detached from the screw cap channel
during transportation, see chapter 4.