KTM Freeride 250 R 2016, Инструкции по установке

Страница: 6 / 23

2 SETUP
4
B01997-01
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp M8 22 Nm
(16.2 lbf ft)
Screw, bottom triple clamp M8 18 Nm
(13.3 lbf ft)
Info
The upper milled groove in the fork leg must be flush with the upper
edge of the upper triple clamp.
Position the bleeder screws toward the front.
M01029-11
–
Remove screws

. Take off the handlebar clamps.
–
Remove screws

. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount and tighten
screws
 .
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
B02301-01
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws evenly.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
–
Install the front wheel. ( p. 8)
S00979-01
–
Position the controls on the right half of the handlebar.
Info
The routing of the cables can be seen in the figure.