SERVICE WORK ON THE CHASSIS 12
83
F01218-10
–
Inject the liquid into the system until it escapes from open-
ing
A
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws
bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
4 mm (0.16 in)
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
12.45
Removing the engine guard
E00964-10
–
Remove screws
1
and
2
.
–
Lower the engine guard at the rear and remove it toward the
front.
12.46
Installing the engine guard
E00964-10
–
Position the engine guard on the frame at the front and mount
screws
1
but do not tighten yet.
–
Position the engine guard on the frame at the rear and mount
and tighten screws
2
.
Guideline
Screw, engine guard
M6x20
10 Nm (7.4 lbf ft)
–
Tighten screws
1
.
Guideline
Screw, engine guard
M6x12
10 Nm (7.4 lbf ft)
