KTM F7103U6, Инструкции по установке, Страница: 7 / 47

SETUP 2
5
H02538-10
(150 XC
‑
W TPI US)
–
Position the combination instrument on the upper
triple clamp.
–
Mount and tighten screws
2
with the collar bushings.
Guideline
Remaining screws,
chassis M6 10 Nm
(7.4 lbf ft)
–
Route the clutch line with the clutch master cylinder
toward the front between the upper and lower triple
clamps.
–
Install the fork legs. ( p. 23)
S01414-10
–
Remove screws
3
and take off the handlebar supports.
–
Move the handlebar supports to the desired position and
mount and tighten screws
3
.
Guideline
Screw, handle-
bar support M10 40 Nm (29.5 lbf ft)
Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
E00483-01
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
or bent.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten the screws
evenly.