KTM F3001P2 2016, Инструкции по установке, Страница: 6 / 29

3 SETUP
4
3.1 Unpacking and setting up the vehicle
C00858-10
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during the setup, leave the protective
film on the vehicle until you have finished.
–
Remove the separate enclosure and unpack it. Check that the scope of supply is
complete on the basis of the enclosed packing list.
–
To be in compliance with the homologation of the vehicle, mount all of the parts in
the separate enclosure when assembling the vehicle.
Info
It is not necessary to mount all of the parts in the separate enclosure for the
vehicle to operate correctly. However, homologation will not apply if not all
parts from the separate enclosure are mounted.
–
Remove the KTM PowerPack. ( p. 17)
–
Have a lift stand available.
Lift stand (54829055000)
–
Carefully loosen and remove the tension belt of the footrest bracket.
Info
An assistant prevents the motorcycle from falling over.
402050-01
–
Together with an assistant, take the vehicle off the palette.
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
0 0
0 0
C00761-10
–
Remove screws

. Take off the handlebar clamps.
–
Remove screws

. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount and tighten
screws

.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
Info
Position the left and right handlebar supports evenly.
C00860-01
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws evenly.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.