KTM F3001P2 2016, Инструкции по установке, Страница: 13 / 29

4 SERVICE WORK
11
4.6 Checking the battery discharge plug form ring
Condition
The KTM PowerPack has been removed.
The covering cap has been removed.
C00776-10
–
Check the battery discharge plug form ring

on the electric motor.
» If the battery discharge plug form ring is dirty:
–
Ascertain that the discharge plug is de-energized. ( p. 22)
–
Clean the form ring without using water or compressed air.
–
Cover the contacts and spray silicone spray onto the form ring.
» If the battery discharge plug form ring is damaged:
–
Change the battery discharge plug form ring. ( p. 23)
4.7 Installing the shock absorber
K00043-11
Main work
–
Push splash protector

to the side and position the shock absorber.
–
Mount and tighten screw

.
Guideline
Screw, top shock absorber M12 80 Nm
(59 lbf ft) Loctite ® 2701™
–
Mount and tighten screw

.
Guideline
Screw, bottom shock
absorber M12 80 Nm
(59 lbf ft)
Loctite ® 2701™
Info
The heim joint for the shock absorber at the swingarm is Teflon-coated. It
must not be greased with grease, nor with any other lubricants. Lubricants
dissolve the Teflon coating, thereby drastically reducing the service life.
–
Mount and tighten screw

.
Guideline
Screw, upper subframe M10 45 Nm
(33.2 lbf ft) Loctite ® 243™
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 9)
–
Install the KTM PowerPack. ( p. 18)
(Option: HV 2 technical personnel)
–
Perform an equipotential bonding check (KTM PowerPack installed).
( p. 23)
–
Lock the seat. ( p. 13)
4.8 Installing the front wheel
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.