KTM 890 ADVENTURE 2022, Руководство пользователя

Страница: 117 / 171

WHEELS, TIRES 15
115
Warning
Danger of accidents There is no braking effect to start with at the rear brake after installing the rear
wheel.
–
Actuate the foot brake several times before going on a ride until you can feel a firm pressure point.
Main work
–
Check the rear hub damping rubber pieces. ( p. 116)
F02059-10
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Remove spacer.
–
Clean and grease shaft seal ring
1
and contact surface
A
of
the spacer.
Long-life grease ( p. 160)
–
Insert a spacer.
–
Clean and grease the thread of the wheel spindle and nut.
Long-life grease ( p. 160)
–
Clean and grease the wheel spindle.
Long-life grease ( p. 160)
–
Clean the contact areas on the brake caliper bracket and link
fork.
F02060-10
–
Engage the thrust bearing of brake caliper bracket
B
and the
link fork.
–
Jack up the rear wheel into the link fork, position it, and insert
the wheel spindle.
The brake linings are correctly positioned.
–
Place the chain on the sprocket.
–
Position chain adjuster
2
. Mount nut
3
, but do not tighten
it yet.
Info
Mount the left and right chain adjusters in the same
position.
–
Make sure that chain adjusters
2
are fitted correctly on the
adjusting screws. Tighten nut
3
.
Guideline
In order for the rear wheel to be correctly aligned, the mark-
ings on the left and right chain adjusters must be in the
same position relative to reference markings
C
.
Nut, rear wheel
spindle M25x1.5 90 Nm (66.4 lbf ft)
Thread and contact area
of wheel spindle greased
–
Position wheel speed sensor
4
in the hole.
–
Mount and tighten screw
5
.