KTM 690 ENDURO AUS/UK 2008, Руководство пользователя

Страница: 69 / 179

0 0 B B
0 0 A A
MAINTENANCE WORK ON CHASSIS AND ENGINE
67
9.16
Adjusting the handlebar angle
x
100279-10
–
Loosen screw

.
–
Move the handlebar to the desired position and slightly tichten the screws.
–
Move the handlebar carefully in both directions as far as it will go.
» If the handlebar instruments touch the fuel tank:
–
Correct the handlebar angle.
Info
The distance between the handlebar support and the handlebar clamp
must be the same at the front and rear.
–
Fully tighten screw

.
Specification
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Loctite ® 243™
9.17
Handlebar position
400271-11
On the upper triple clamp, there are 2 holes at a distance

to each other.
Distance

between holes 15 mm (0.59 in)
The holes on the handlebar support are placed at a distance

from the center.
Distance

between holes 3.5 mm (0.138 in)
The handlebar can be mounted in 4 different positions. In this way, the handlebar can be
installed in the position most comfortable for the rider.