KTM 65 SX 2017, Инструкции по установке, Страница: 5 / 14

2 SETUP
3
2.1 Unpacking and setting up the vehicle
201951-10
–
Open the box.
Info
To avoid damaging the vehicle while setting it up, do not remove the protec-
tive film on each component until installing the component, and leave it on
the vehicle where possible until work has been completed.
–
Remove the front wheel, fender, and the separate enclosure from the box.
–
Remove the separate enclosure and unpack it. Check that the scope of supply is
complete on the basis of the enclosed packing list.
–
Lift the vehicle out of the box with the assistance of another person.
–
Raise the motorcycle with a lift stand. ( p. 4)
–
Check the vehicle for transport damage.
201952-10
–
Loosen screws  .
–
Remove the wheel spindle.
–
Install the front fender. ( p. 6)
–
Install the front wheel. ( p. 4)
–
Remove the protective film from the handlebar and start number plate.
K00344-10
–
Position the handlebar with handlebar clamps  .
–
Mount and tighten the screws.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
–
Check the handlebar position.
» If the handlebar position is not adjusted as required by the customer:
–
Adjust the handlebar position. ( p. 5)
–
Remove the screw of brake line guide

. Position the brake line. Mount the brake
line guide again and tighten the screw.
–
Check that the wiring harness, throttle cables, and brake line have the necessary
freedom of movement and are correctly routed.
–
Check that the controls on the handlebar are correctly positioned and firmly seated.
800042-10
–
Mount the footrests with the springs and pins. Secure the pins using the washers
and cotter pins.
Pliers for footrest spring (58429083000)
–
Fill up with fuel. ( p. 6)
–
Prepare the vehicle according to the specifications in the
KTM Dealer.net
for han-
dover to the customer.