KTM 350 EXC-F AUS 2014, Инструкции по установке

Страница: 15 / 24

3 WORK
13
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. ( p. 11)
–
Disconnect the negative cable of the battery to avoid damage to the onboard elec-
tronics.
400240-10
Main work
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test the open-circuit voltage and starting
voltage of the battery, and to test the alternator. With this device, you cannot over-
charge the battery.
Info
Never remove lid
1
.
Charge the battery with a maximum of 10% of the capacity specified on
battery housing
2
.
–
Switch off the battery charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage, and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
–
Mount the seat. ( p. 11)
3.14 Opening filler cap
Danger
Fire hazard Fuel is highly flammable.
–
Never refuel the vehicle near open flames or burning cigarettes, and always switch off the engine first. Be careful that no
fuel is spilt, especially on hot vehicle components. Clean up spilt fuel immediately.
–
The fuel in the fuel tank expands when warm and may emerge if overfilled. Follow the instructions on refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Store fuel properly in a suitable canister and keep away from children.
Warning
Environmental hazard Improper handling of fuel is a danger to the environment.
–
Do not allow fuel to get into the ground water, the ground, or the sewage system.
B01502-10
–
Press release button
1
, turn filler cap counterclockwise and lift it upwards and
remove.