18
CLEANING, CARE
82
18.1
Cleaning the motorcycle
Note
Material damage
Damage and destruction of components by high-pressure cleaning equipment.
–
When cleaning the vehicle with a pressure cleaner, do not point the water jet directly onto electrical components, connectors,
cables, bearings, etc. Maintain a minimum distance of 60 cm between the nozzle of the pressure cleaner and the component.
Excessive pressure can cause malfunctions or destroy these parts.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
401061-01
–
Close off the exhaust system to prevent water from entering.
–
First remove coarse dirt particles with a gentle spray of water.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a
paintbrush.
Motorcycle cleaner (
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to the dry vehicle; always rinse with water
first.
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Remove the plug from the exhaust system.
Warning
Danger of accidents
Reduced braking efficiency due to a wet or dirty brake
system.
–
Clean or dry a dirty or wet brake system by riding and braking gently.
–
After cleaning, ride a short distance until the engine reaches operating tempera-
ture.
Info
The heat produced causes water at inaccessible locations in the engine and
the brake system to evaporate.
–
Push back the protection caps of the handlebar controls to allow any water that has
penetrated to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. (
–
Treat bare metal parts (except for brake discs and the exhaust system) with a corro-
sion inhibitor.
Preserving materials for paints, metal and rubber (
–
Treat all plastic parts and powder-coated parts with a mild cleaning and care agent.
Special cleaner for glossy and matte paint finishes, metal and plastic surfaces
Содержание 2015 450 SC-F USA
Страница 1: ...OWNER S MANUAL 2015 450 SX F EU 450 SX F USA 450 XC F USA Art no 3213176en ...
Страница 2: ......
Страница 100: ...24 AUXILIARY SUBSTANCES 98 Universal oil spray Recommended supplier Motorex Joker 440 Synthetic ...
Страница 105: ... 3213176en 3213176en 4 2014 KTM Sportmotorcycle AG 5230 Mattighofen Austria http www ktm com Photo Mitterbauer KTM ...