KTM 200 DUKE 2021, Руководство пользователя

Страница: 99 / 119

TROUBLESHOOTING 21
97
Faults Possible cause Action
The engine does not turn when
the start button is pressed Operating error
–
Carry out start procedure. ( p. 37)
12-V battery discharged
–
Charge the 12-V battery. ( p. 74)
Fuse 1 , 3 , 4 , or 8 is blown
–
Change the fuses of individual electri-
cal power consumers. (
p. 77)
No ground connection present
–
Check the ground connection.
Engine turns only if the clutch
lever is drawn The vehicle is in gear
–
Shift the transmission into neutral.
The vehicle is in gear and the
side stand is folded out
–
Shift the transmission into neutral.
Engine turns but does not start Operating error
–
Carry out start procedure. ( p. 37)
Malfunction in the electronic
fuel injection
–
Read out the fault memory using the
KTM diagnostics tool.
Engine has too little power Air filter is very dirty
–
Change the air filter.
Fuel filter is very dirty
–
Check the fuel pressure.
Malfunction in the electronic
fuel injection
–
Read out the fault memory using the
KTM diagnostics tool.
Engine overheats Too little coolant in cooling sys-
tem
–
Check the cooling system for leakage.
–
Check the coolant level. ( p. 81)
Radiator fins very dirty
–
Clean the radiator fins.
Foam formation in cooling sys-
tem
–
Drain the coolant. ( p. 83)
–
Fill/bleed the cooling system.
(
p. 84)
Thermostat defective
–
Check the thermostat.
Fuse 5 blown
–
Change the fuses of individual electri-
cal power consumers. (
p. 77)
Defect in radiator fan system
–
Check the radiator fan system.
Malfunction indicator lamp
lights up yellow Malfunction in the electronic
fuel injection
–
Read out the fault memory using the
KTM diagnostics tool.
Engine dies during the trip Lack of fuel
–
Refuel. ( p. 43)
Fuse 1 , 3 , 4 , or 8 is blown
–
Change the fuses of individual electri-
cal power consumers. (
p. 77)
The ABS warning lamp lights
up ABS fuse blown
–
Change the ABS fuses. ( p. 75)
Large difference in wheel
speeds of the front and rear
wheels
–
Stop the vehicle, switch off the igni-
tion, and start it again.
Malfunction in ABS
–
Read out the fault memory using the
KTM diagnostics tool.
High oil consumption Engine vent hose bent
–
Route the vent hose without bends or
change it if necessary.
Engine oil level too high
–
Check the engine oil level. ( p. 90)
Engine oil too thin (low viscos-
ity)
–
Change the engine oil and oil filter,
clean the oil screen.
( p. 90)
Headlight and position light are
not functioning Fuse 6 blown
–
Change the fuses of individual electri-
cal power consumers. (
p. 77)
Turn signal, brake light, and
horn are not functional Fuse 6 blown
–
Change the fuses of individual electri-
cal power consumers. (
p. 77)