ENGLISH
26
Adjust idling speed*
Idling adjustment of the carburetor strongly affects the engine’s starting
behavior. That is, an engine whose idling speed is adjusted correctly will be
easier to start than one whose idling speed has not been adjusted correctly.
The throttle stop screw
1
is used to adjust the basic position of the slide.
Turning in clockwise direction will increase the idling speed, turning in
counterclockwise direction will reduce the idling speed. Normal idling
speed 1400 - 1500 rpm.
Adjusting the two throttle cables*
There must always be a 3-5 mm (0.1-0.2 in) play in both throttle cables.
To check this, move back the protective covers
3
on the throttle grip. You
must be able to lift the outer covering of the cable 3-5 mm from the adju-
sting screw
4
, until resistance is felt.
To adjust, loosen the counter nut
5
and turn the adjusting screw accor-
dingly. Finally tighten counter nut and slide the protective covers back on.
Adjusting the choke cable*
At the choke cable, there must always exist a play of approx. 2 mm (0.1
in). To check this, push choke lever fully forward and pull protective cover
6
from the adjuster piece
7
. Now, it must be possible to lift the outer
covering of the cable by approx. 2 mm from the adjuster piece until feeling
a resistance. If necessary, loosen counter nut and readjust play by turning
the adjuster piece. Tighten counter nut, and slide on protective cover.
Adjusting the clutch cable
When the engine is cold, the play at the clutch lever should be 10 mm (0.4 in)
(measured at the outer edge).
To adjust the clutch cable turn the adjusting nut
8
accordingly.
2 mm
1–3 mm
3-5 mm
5
4
3
7
6
8
+
–
Содержание 1998 400 R
Страница 1: ...98 OWNER S HANDBOOK 11 97 400 620 R XC e...
Страница 2: ......
Страница 38: ...ENGLISH 36 Schal...
Страница 39: ...ENGLISH 37 ltplan...