KTM 125 SX EU 2013, Инструкции по установке

Страница: 12 / 20

3 WORK
10
Info
Even when there is no load on the battery, it still loses power steadily.
The charge state and the type of charge are very important for the service life of the battery.
Rapid recharging with a high charging current shortens the battery's service life.
If the charging current, charging voltage and charging time are exceeded, electrolyte escapes through the safety valves. This
reduces the battery capacity.
If the battery is depleted from starting the vehicle repeatedly, the battery must be charged immediately.
If the battery is left in a discharged state for an extended period, it will become over-discharged and sulfate, destroying the
battery.
The battery is maintenance-free, i.e., the acid level does not have to be checked.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. ( p. 9)
–
Disconnect the negative cable of the battery to avoid damage to the motorcycle's
electronics.
400240-10
Main work
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the alternator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove lid
1
.
Charge the battery with a maximum of 10% of the capacity specified on the
battery housing
2
.
–
Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
–
Mount the seat. ( p. 9)
3.9 Installing the battery (250/300 XC)
101712-10
Main work
–
Insert the battery into the battery compartment with the terminals facing to the
front.
Battery (YTX4L-BS)
–
Reconnect rubber band
1
.
–
Connect positive cable
2
and negative cable
3
.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Info
Contact disks
A
must be mounted between screws
4
and cable sockets
5
with the claws facing down.
–
Slide positive terminal cover
6
over the positive terminal.
Finishing work
–
Mount the seat. ( p. 9)