KTM 125 SX EU 2013, Инструкции по установке

Страница: 11 / 20

3 WORK
9
–
Position the brake line. Position the clamp and mount and tighten screw
2
.
3.6 Removing the seat
101683-10
–
Remove screw
1
. Lift up the seat at the rear, pull it back and then remove from
above.
3.7 Mounting the seat
101730-01
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower at the rear
and simultaneously push forward.
–
Make sure that the seat is correctly locked in.
101683-10
–
Mount and tighten screw
1
of the seat fixation.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
3.8 Recharging the battery (250/300 XC)
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Warning
Environmental hazard
The battery contains elements that are harmful to the environment.
–
Do not discard batteries with the household trash. Dispose of a defective battery in an environmentally compatible manner.
Give the battery to your KTM dealer or to a recycling center that accepts used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.