KTM 125 SX EU 2013, Инструкции по установке

Страница: 10 / 20

3 WORK
8
101745-11
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease shaft seal rings
1
and bearing surface
A
of the spacers.
Long-life grease ( p. 16)
–
Insert the spacers.
101744-11
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel spindle M24x1.5 45 Nm
(33.2 lbf ft)
–
Operate the hand brake lever several times until the brake linings are lying correctly
against the brake disc.
–
Remove the motorcycle from the lift stand. ( p. 7)
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Tighten screws
3
.
Guideline
Screw, fork stub M8 15 Nm
(11.1 lbf ft)
3.4 Installing the front fender
101724-10
Main work
–
Position the front fender. Mount and tighten screws
1
and
2
.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Finishing work
–
Install the start number plate. ( p. 8)
3.5 Installing the start number plate
101681-10
–
Position the start number plate. Mount and tighten screw
1
.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Info
Ensure that the holding lugs engage in the fender.