SETUP
4
Info
The topmost milled groove in the fork leg must be flush with the top
edge of the upper triple clamp.
Position the bleeder screws toward the front.
400223-10
–
Remove screws
1
. Take off the handlebar clamps.
–
Remove screws
2
. Remove the handlebar supports.
–
Place the handlebar supports in the required position. Mount and tighten
screws
2
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Loctite
®
243™
Info
Position the left and right handlebar supports evenly.
600824-10
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount and tighten the screws.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the center of the handlebar
clamps.
Keep the gap widths equal when tightening.
B00903-10
(All EXC models)
–
Insert the indicator lamp with the blue and brown cable colors into socket
3
.
–
Insert the indicator lamp with the blue and violet cable colors into socket
4
.
B00904-10
(XC-W)
–
Connect pull switch
5
with the yellow and white cables.