KTM 125 Duke 2016, Инструкции по установке

Страница: 5 / 17

2 SETUP
3
2.1 Unpacking and setting up the vehicle
S00786-10
–
Remove the straps and box.
S00790-10
–
Remove the adhesive tape in the upper area of the motorcycle.
S00789-10
–
Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking, leave the other films
on the vehicle until you have finished work on the vehicle.
–
Remove the separate enclosure and unpack it. Check the separate enclosure for
completeness.
–
Check the vehicle for transport damage.
B00912-01
–
Position the handlebar.
The lettering on the handlebar is situated in the middle of the handlebar
clamp.
–
Position the handlebar clamps. Mount and tighten the screws evenly.
Guideline
Screw, handlebar clamp M8 21 Nm
(15.5 lbf ft)
Loctite
®
243™
B00913-01
–
Mount and tighten the rear mirror on both sides.
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
700217-01
–
Mount the reflector.
–
Remove the protective plastic.
–
Carefully loosen and remove the tensioning belt over the swingarm.
Info
An assistant prevents the motorcycle from falling over.
–
Carefully loosen and remove the tensioning belts around the lower triple clamp.
The vehicle is released at the front.