KTI Networks KGS-810F, Руководство пользователя

Страница: 30 / 70

-30-
Configuration Description
MAC Address The MAC address factory configured for the switch
It can not be changed in any cases.
S/W Version The firmware version currently running
H/W Version The hardware version currently operating
Active IP Address Currently used IP address for the switch management
Active Subnet Mask Currently used subnet mask for IP address for the switch management
Active Gateway Currently used gateway IP address for the switch management
DHCP Server Current IP address of the DHCP server
Lease Time Left The time left for the lease IP address currently used
DHCP Enabled Use DHCP to get dynamic IP address configuration for the switch
Fallback IP Address IP address used when DHCP mode is not enabled
Fallback Subnet Mask Subnet mask for IP address used when DHCP mode is not enabled
Fallback Gateway Default gateway IP address used when DHCP mode is not enabled
WDT Enable WDT (Watch Dog Timer)
Management VLAN Set management VLAN information
- VID VLAN ID configured for web management to the switch
- CFI CFI value for web reply packets from the switch
- User priority Priority value for web reply packets from the switch
Name * Set the system name for this switch unit
Password Set new password
SNMP enabled Enable SNMP agent
SNMP Trap destination The IP address of the SNMP trap manager
SNMP Read community The community allowed for the SNMP [ get ] message
SNMP Write community The community allowed for the SNMP [ set ] message
SNMP Trap community The community used for the SNMP trap messages sent by the switch
[Apply] Click to apply the configuration change
[Refresh] Click to refresh current configuration
Note:
1. It is suggested to give each switch unit a system name as an alternative unique identification beside IP
address.
2. Setting change of DHCP mode takes effective in next bootup.
3. A watch dog timer (WDT) is a hardware timing device that triggers a system reset if the system firmware, due to
some fault condition, such as a hang, neglects to regularly service the watch dog timer. The intention is to bring
the system back from the hung state into normal operation. The timer is set to 1.72 seconds in this switch.