8. OSD MANUAL
WHITE BAL
Modes:
ATW, Push, User1, User2, Anti CR, Manual, Pushlock
(Adjusts the white balance to suit area being viewed)
ATW (Auto Trace White balance)
Speed:
0 to 255 (increments of 1)
(Adjusts the pull in speed of ATW)
Delay Cnt:
0 to 255 (increments of 1)
(Sets the time-based hysteresis of ATW)
ATW Frame:
x0.5, x1, x1.5, x2
(Sets the pull in frame magnification)
Environment:
Indoor, Outdoor
(Preset for either indoor or outdoor applications of the ATW)
Push:
Sets the mean of the Auto White Balance (AWB) of the area viewed
User 1 & 2:
Both User1 & 2 can be individually set up for specific applications.
B-Gain:
0 to 255 (increments of 1)
R-Gain:
0 to 255 (increments of 1)
Anti CR:
When shut+auto iris mode used, this setting can reduce (but may
not eliminate) colour roll caused by fluorescent lighting.
Manual:
A single scale, simultaneous adjustment of the B and R gain values
Level:
28 ~ 134 (increments of 1)
(The lower the number, the higher content of Red, the higher the number the
higher content of Blue in the image)
Pushlock:
Sets the white balance based on the lighting level at the camera
at that time (Best used when there is no change in the illumination level)
BACKLIGHT
Modes:
Off, BLC, HLC.
BLC:
Globally applies non adjustable BLC (Back Light Compensation) to the image
HLC:
Globally applies non adjustable HLC (High Light Compensation – Peak
White Inversion) to the image
15
