KT DE721, Инструкция по эксплуатации, Страница: 4 / 8

6. Safety Symbols
Meets with EMC.
Environmental Protection! Do not dispose of electric tools in the trash! According to
the European Directive 2002/96/EC on electrical and electronic equipment useless,
after its conversion into national law, shall be accumulated separately power tools to
be submitted to an ecological recycling.
7. Guarantee
For this device BIMER SYSTEMS gives a warranty from date of purchase (verified by invoice
or delivery note) 1 year. The defects will be repaired or will be a replacement of the
equipment as deemed appropriate. Not covered under warranty damages caused by wear,
overuse or misuse Claims can only be accepted if the device If received by Bimer technical
personnel, an authorized dealer, or the distributor without being disassembled.
5. Maintenance Instructions :
•
Check cable connection to the network, if see that is defective replace it immediately for
another of similar characteristics.
•
The methacrylate doors tend to become opaque over time due to the oxidizing power of
ozone, do not try to polish it or replace it with glass doors, the glass can cause accidents.
•
Replace the electronic circuit every two years thus ensures proper disinfection.
•
For cleaning and maintenance operations of the device. ALWAYS DISCONNECT THE
POWER SUPPLY.
•
NEVER CLEAN THE DEVICE WITH WATER PRESSURE.
•
Cleaning frequency depends on the humidity and that the tools will completely dry or not.
The higher these variables, most often have to clean the device.
•
Clean stainless steel with specific products for this type of material using a wet cloth, never
use spray to prevent the ozone lamp imbued with these products this way will also avoid
short circuits because of humidity. The device must be dried properly. Dry well the protector
located on the top (do not remove it) If need to be removed due to the humidity, should be
done by qualified personnel.
•
In the models that have magnetic supports should be cleaned at least once a month. These
supports that need of ferrous materials to produce magnetization should be checked and
cleaned in dry with a cloth type scotex that produces small abrasion.
•
Rub gently to remove the rust. Then pass a wet cloth to remove excess dirt, wipe with a
cloth soaked in oil suitable for food and rub on the side of the magnets, with a little film will
be enough. This will retard oxidation.
•
If the cabinet does not work check the fuse B2 of B base is correct, to remove disconnect
the network cable, on the side is a groove insert a flat screwdriver to pry up and remove the
fuse holder. Inside there is a spare fuse. Replace the fuse, if that still does not work call for
service.
ДЕКЛАРАЦИЯ О СООТВЕТСТВИИ
ЮРИДИЧЕСКОЕ ЛИЦО:
ООО «Бимер Системс» (Bimer Systems S.L.U.),
зарегистрированное по адресу ул. Кальварио д.40 г.Мадригерас
(Альбасете), Испания 02230 (Calle Calvario, 40 Codigo
Postal 02230 de Madrigueras (Albacete) España)
СВИДЕТЕЛЬСТВУЕТ, ЧТО ПРИБОРЫ, УКАЗАННЫЕ
НИЖЕ
НАХОДЯТСЯ В
СООТВЕТСТВИИ С ДИРЕКТИВОЙ ОБ
ЭЛЕКТРОПРИБОРАХ 98/37/CE И ЭМС 2004/108/CE.
МОДЕЛЬ: ОЗОНОВЫЙ ДЕЗИНФЕКТОР НОЖЕЙ.
КОДЫ: DE721SM, DE721CR
МЕСЯЦ И ГОД ПРОИЗВОДСТВА: 01/2016
KONETEOLLISUUS OY SF
01801 KLAUKKALA, FIN-
LAND.
Tel: 358 987 892 20