Krups BW802852, Руководство пользователя

Страница: 10 / 36

10
IN THE EVENT OF PROBLEMS
PREVENTION OF DOMESTIC ACCIDENTS
THERE IS NO EVIDENT DAMAGE TO YOUR KETTLE
„
The kettle does not work
– Check that your kettle is properly connected.
– The kettle has been switched on without water or an accumulation of scale has caused
the overheat cut-out to operate: allow the kettle to cool and fill it with water. Descale first
if scale has accumulated.
Switch it on: the kettle should start working again after about 15 minutes.
IF YOUR KETTLE HAS BEEN DROPPED, IF IT LEAKS OR IF THERE IS VISIBLE DAMAGE
TO THE POWER CORD, THE PLUG OR THE BASE OF THE KETTLE
Return your kettle to your After-Sales Service Centre, only they are authorised to carry out
repairs. See the guarantee conditions and list of centres in the booklet supplied with your
kettle. The type and serial number are shown on the bottom of your kettle. This guarantee
covers manufacturing defects and domestic use only. Any breakage or damage resulting
from failure to comply with the instructions for use is not covered by the guarantee.
„
The manufacturer reserves the right to modify the characteristics or components
of its kettles at any time in the interests of the consumer.
„
Do not use the kettle if damaged. No attempt must be made to dismantle the
kettle or its safety devices.
„
If the supply cord is damaged, it must be replaced by the manufacturer, its after-
sales service centre or a similarly qualified person, in order to avoid any danger.
For a child, a burn or scald, even if slight, can sometimes be serious.
As they grow up, teach your children to beware of hot liquids to be found in the kitchen.
Position the kettle and its supply cord well to the rear of the work surface, out of the reach
of children.
If an accident does occur, run cold water over the scald immediately and call a doctor if
necessary.
„ In order to avoid any accident: do not carry your child or baby at the same time as drinking
or carrying a hot drink.
*depending on model
„
Empty your kettle and rinse 5 or 6 times. Repeat if necessary.
To de-scale your filter*
Soak the filter in white vinegar or diluted citric acid.
„
Never use a de-scaling method other than that recommended.