Kronen-Mixer KM-2
14
Instruction Manual
5. ELECTRICAL CONNECTION
The
power supply voltage must correspond
to the values on the
rating plate on the appliance (the voltage rating is given in volts [V]
The appliance should only be connected to a
single phase grounded
alternating current.
Make sure that the original mains cable and
the wall outlet correspond.
Appliances with a 230 V designation can also be used with a 220 V mains supply.
6. PUTTING INTO OPERATION
Before using the appliance for the first time it must be
thoroughly cleaned.
Follow the instructions in the chapter „Cleaning“.
Place the blender on a
firm, flat base
(ergonomic working height)
and plug it into a
nearby, appropriate electrical outlet.
7. OPERATING INSTRUCTION
- Insert the cutter head together with the gasket into the threaded ring.
- Screw the bowl turning counter clockwise into the threaded ring.
- Always ensure that it is inserted straight.
The cutter blades are sharp and may cause
bad injuries.
If at all possible, avoid using an extension cord. If it is unavoidable, only proper, approved
extension cords should be used.
Do not subject the mains cable to strong tension or pressure.
To replace the cable
, see chapter “Repairs“.
For safety reasons the outlet must have a faulty-energy-protection switch (FI).
Container assembly
Note
The windings of the commutator motors are covered with high-quality insulating
lacquer. For this reason, the motor may, at first, exude an odour when it heats up.
This is normal and does not damage the motor; it disappears after the motor has been
used several times.
Before connecting the appliance to the mains electricity supply it must be
switched off at the Speed control knob (Position: “0”) and stood in a stable posi-
tion.
