20
Adjustments
Adjustment with a tandem axle
•
Remove the load from the tandem axle (2) (lower
the chassis)
•
Pull out the spring pin (1)
•
Pull out the bolt (3)
•
Move the tandem axle to the selected position
•
Insert the bolt and secure
3.2 Swather disc tine height adjustment
CAUTION: Adjust the working height of the
swather disc tines according to the conditions.
The working height of the swather disc tines (2) is
adjusted by raising or lowering the rear hydraulics (1).
The distance to the ground should be approx. a = 2 cm.
KWT-0-032
2
a
1
Undercarriage wheel = more acute spreading
direction I
in angle
Undercarriage wheel = more obtuse spreading
direction II
in angle
KWT-0-022
2
3
1
II
I
Wide spreading (tedding)
Drive rpms
Take the mowing swaths as much as possible
between the swather disks.
In cases of heavy fodder, move with high rpm
(540/min) and a not-too-high travel speed (4 - 6
km/h) (steep spreading angle).
Turning
The drier the fodder, the lower the PTO rpm to be
chosen (approx. 450/min), in order to avoid
damaging the fodder. The movement speed (6 - 8
km/h) should be adjusted to the condition of the
fodder. If the fodder is moist, the rpm and the
movement speed should be selected as with wide
spreading (flat spreading angle).
These specifications are approximate
values which will need
to be adjusted in practice to the actual
circumstances.
