Krone EASYCOLLECT 6000, Руководство по эксплуатации, Страница: 28 / 52

III - 10
Start-up
Work on the maize header must only
be performed when the engine is
stopped and turned off and the
ignition key has been removed. All
operating levers must be in the
neutral setting and no hydraulic lines
may be under pressure.
Check the maize header each time
before it is used and after it has been
driven to make certain there are no
impediments.
Worn, used or deformed blades must
be replaced immediately.
The same applies for all fastening
parts.
Do not turn on the drive until the
maize header is in the working
position.
3.7 Using the machine for work
3.7.1 Special safety instructions
Keep persons out of the hazardous
area. If persons do approach the
hazardous area, please turn off the
machine immediately.
Never allow the machine to run
unsupervised.
Check the safety devices each time
before the machine is used. Replace
damaged safety devices immediately.
3.7.2 Using the maize header
• Move the maize header to the working position and
lower it down to the ground or to the wanted cutting
height..
• Turn on the maize header drive and adjust it to
working speed.
• Drive into the crop material with the forage harvester.
• The driving and collector speed should be based on
the conditions of usage at hand (ground conditions,
the height and nature of the crop, etc.).
The collector speed must not be
higher than the speed of drawing the
crop into the cutting unit.
It must be set so high that a clean cut
of the crop is guaranteed.
The travelling speed is based
primarily on the throughput of the
forage harvester.
3.7.3 Lifting gear spacing control
(optional)
The lifting gear spacing control is
available only if spacing sensors (1)
have been fitted.
When the lifting gear spacing control
is active, the control of the forage
harvester sets the height constant
relative to the ground (ground
copying).
1
EC100620