KROHNE UFM 600 T ALTOSONIC, Инструкция по установке и эксплуатации

Страница: 53 / 93

Menu selection:
By entering the main menu, the submenu Start Up 1.0.0. will
be on display; use the key to select the submenus TEST
2.0.0. or INSTALL 3.0.0.
If the Start Up Menu is to be selected, press key when
1.0.0. is displayed.
Function selection:
Use the key to select a function from the chosen sub-
menu.
Activate the selected function by pressing the key.
Enter numbers, characters and select units:
If applicable within a function, numbers, characters or units
can be selected at the position which shows a blinking sign
by using the key.
This position is selected by using the key.
The set up of the function is completed by pressing ; the
data is stored and the menu pointer returns to the active
submenu.
Leave Submenu:
Press to return to the main menu.
Ending the programming session:
Ending a programming session can be done by pressing
3 times while one of the submenus (1.0.0, 2.0.0 or 3.0.0.) is
active.
The programmed parameters will be saved directly without a
request whether the changes should be set.
After saving the parameters the microprocessor will go
directly to the measuring mode.
50
ALTOSONIC
Programming mode
UFM 600 T