KROHNE OPTIWAVE 5200 C, Дополнительное руководство по инструкции

Страница: 17 / 24

COMMISSIONING / OPERATION
4
17
OPTIWAVE 5200 C
www.krohne.com 10/2013 - 4003066901 - MA OPTIWAVE5200C-PA-R01-en-
Status = Limits
Check the first two quality bits in order to get the quality information of the measurement value:
• Good (Non Cascade):
Good (Non Cascade): Good (Non Cascade):
Good (Non Cascade): function block output value is ok and can be used without restrictions
• Good (Cascade):
Good (Cascade): Good (Cascade):
Good (Cascade): will not be supported, because it is not applicable for the device
• Uncertain:
Uncertain: Uncertain:
Uncertain: function block output value can be used but the accuracy can not be guaranteed
(function block outputs value has been frozen, A/D converter is saturated or out of range, ...)
• Bad:
Bad: Bad:
Bad: function block output value is bad - do not use it for process control!
The "Quality-Substatus" and "Limit" bits will be used for further diagnostics or limit checking.
4.6 Diagnosis
The device does internal self-tests. The results are given as detailed diagnosis data that agrees
with PROFIBUS PA Profile 3.02. You can set device parameters to see the diagnosis data and you
can also use an engineering tool (DD/DTM, ...) to read it. Cyclic services transfer diagnosis data
to the control system (PLC, ...).
Diagnosis is bitwise coded. Thus it is possible to report more than one indication simultaneously.
The GSD file contains a text for each diagnosis bit to show a text message in the control system.
The references are specified in the UNIT_DIAG_BIT(i) entries. They show which bit is set to
indicate a special diagnosis event.
The quantity and content of diagnosis data depends on the device settings. The active Ident.
Number and the selected status and diagnosis mode will have an effect diagnosis propagation.
The tables that follow show the diagnosis events which are reported for different settings. The
bit number is equal to the count in the GSD file. It gives the position in the device-related
diagnostic field of the Slave_Diag service.
Diagnosis to control system in case of
• Manufacturer specific Ident. Number (4554hex)
• Profile specific Ident. Number (9700hex)
Quality Quality substatus Limits
Gr Gr QS QS QS QS Qu Qu
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
0 0 = ok
0 1 = low limited
1 0 = high limited
1 1 = constant
INFORMATION!
The status should be monitored because a number will be transmitted even if the status of the
measurement value is bad or uncertain. This is the only way to check the quality of the
transmitted measurement values.