Kripsol KS, Руководство пользователя

Страница: 31 / 95

SYMPTOM
POSSIBLE CAUSE
Locate and remove the obstruction. See the corresponding section
of this manual for instructions on how to disassemble the pump.
Try to prime the pump again. Check the intake system for air leaks.
Check the impellor for wear on the seals.
See repair instructions.
Inspect and repair.
Compare the pressure and flow of the pump on the pump curve.
Check that the valve on the discharge is not partially or fully closed.
Reduce the pressure requirements of the installation.
Locate and remove the obstruction.
Check the intake pipe for obstructions, leaks, open by-pass valves, etc.
If necessary, reduce the flow by partially closing the discharge valve.
Install the pump as close as possible on the vertical line of the
intake tank.
Obstructed flow.
The pump doesn't prime.
Internal leaks.
Missing parts.
The pressure required for the
installation is higher than the
pump pressure.
Obstructionontheintake.
The pump pressure is higher than
the installation pressure for the
defined flow.
The intake height exceeds 3 m.
2.MECHANICAL
3.INSTALLATION
3.1
2.1
2.2
2.3
2.4
3.2
3.3
3.4
10. TABLE OF CONDUCTORS AND CIRCUIT BREAKERS
●
This table applies to both 50Hz y 60Hz
32
FREQUENCY VOLTAGE
CIRCUIT
BREAKER
RANGE
CABLE SECTION
0,33 HP 50/60 Hz 230 V
230 V
230 V
400 V
SINGLE-PHASE
SINGLE-PHASE
THREE-PHASE
SINGLE-PHASE
THREE-PHASE
SINGLE-PHASE
THREE-PHASE
SINGLE-PHASE
THREE-PHASE
SINGLE-PHASE
THREE-PHASE
THREE-PHASE
1.6 - 2.5 A
1.6 - 2.5 A
1.0 - 1.6 A
1.6 - 2.5 A
1.6 - 2.5 A
6.3 - 10 A
2.5 - 4 A
2.5 - 4 A
2.5 - 4 A
2.5 - 4 A
2.5 - 4 A
2.5 - 4 A
4 - 6.3 A
4 - 6.3 A
4 - 6.3 A
6.3 - 10 A
4 - 6.3 A
6.3 - 10 A
50/60 Hz
50/60 Hz
50/60 Hz
50/60 Hz
50/60 Hz
50/60 Hz
0,50 HP
0,75 HP
1,00 HP
1,50 HP
2,00 HP
3,00 HP
1.5 mm ² - AWG 15
2.5 mm ² - AWG 15
1.5 mm
² - AWG 15
2.5 mm ² - AWG 15
1.5 mm ² - AWG 15
2.5 mm ² - AWG 15
1.5 mm ² - AWG 15
2.5 mm ² - AWG 15
230 V
230 V
400 V
230 V
230 V
400 V
230 V
230 V
400 V
230 V
230 V
400 V
230 V
400 V
MOTOR
POWER
SINGLE-PHASE /
THREE-PHASE
SINGLE-PHASE
10 - 16 A 230 V
4 mm ² - AWG 11