KRESS KU760, Инструкция по безопасности и эксплуатации

Страница: 8 / 12

8
Cut off saw KU760
COMPONENT LIST
1. HANDLE
2. SWITCH SELF-LOCKING KNOB
3. SWITCH
4. MOVABLE SHIELD
5. SLICING
6. UNLOCK KEY
7. SCREW HANDLE
8. FASTENING SCREW ROD
9. SPANNER
10. BASE
11. FIXED BAFFLE PLATE FIXING BOLT A
12. FIXED BAFFLE PLATE
13. FIXED BAFFLE PLATE FIXING BOLT B
14. CUTTING DEPTH ADJUSTMENT BOLT
15. ARM RETAINING PIN
16. ARM
17. SPINDLE
18. EXTERNAL PRESSING PLATE
19. WASHER
20. HEX BOLT
21. SPARK BAFFLE
22. SPINDLE LOCKING KNOB
Some of the accessories mentioned in
illustrations or texts are not included in the
scope of supply.
TECHNICAL DATA
Rated voltage
220-230V~50Hz
Rated input power
2200W
Rated no-load speed
3900r/min
Disc size
355mm
Disc bore
25.4mm
Machine weight
16kg
Protection class
/II
ACCESSORIES
Spanner 1
355mm resin cutting slice 1
Recommend to choose your accessories from the store
where you purchased the power tool. Please select the
right accessory based on your work. Please refer to the
accessory package for more methods and assistance
of using the accessory.
OPERATING
INSTRUCTIONS
NOTE: Please read the instructions
carefully before using the machine.
In order to ensure the safety of operating, the machine
base must be placed on a firm and flat surface (e.g.,
worktable, flat ground, etc.).
1. Arm fixing
Be sure to pull out the plug before doing any
repairs to the machine.
Using the arm fixing pin (15) to fix the arm helps to carry
the machine, thereby alleviating the inconvenience of
handling the machine.
Fixing the Machine (Handling Position)
Put the handle (1) down to the lowest position, push the
arm retaining pin (15) inward, and let go.
Unlocking (Working position)
Push down the handle (1) slightly, pull out the arm
retaining pin (15) outward, and lift the arm slowly
upward.
Before operating the machine, check whether the arm
fixing button has been pulled out, if not, the arm can
not be moved to the desired position.
2.Replacement of slices (see figure B)
Be sure to pull out the plug before doing any
repairs to the machine.
When choosing slices, be sure to refer to the
specifications provided in this manual.
The allowable speed of the slice shall not be lower than
the idle speed of the machine.
The spindle locking function can only be used after the
slice is completely stopped.
Removal of slices
Adjust the machine to the highest point.
Push the movable shield (4) upward to the end.
Rotate the hex bolt (20) with the wrench (9) attached to
the machine, and push and press the spindle locking
button (22) at the same time until the spindle is locked.
Press the spindle locking switch, turn out the hex
bolt (20), take out the external pressure plate (18) and
washer (19).
Remove slices (5).
Installation of slices
If necessary, clean the relevant parts thoroughly before
installation.
Install the new slice on the spindle (17). The labeled