KREMLIN REXSON
Page 4
Manual : 574.243.112
FIRE - EXPLOSION - SPARKS - STATIC ELECTRICITY HAZARDS
A poor earth connection, inadequate ventilation, sparks or static electricity can cause an explosion
or fire. to avoid these risks when using or servicing KREMLIN REXSON equipment, the following
safety procedures must be followed :
•
ensure a good earth connection and ground the parts to be handled i.e. solvents, materials,
components and equipment,
•
ensure adequate ventilation,
•
keep working area clean and free from waste solvents, chemicals, or solid waste i.e. rags,
paper and empty chemicals drums,
•
never use electrical switches / power if in an atmosphere of volatile solvent vapour,
•
stop working immediately in case of electrical arcs,
•
never store chemicals and solvents in the working area.
TOXIC PRODUCT HAZARDS
Toxic products or vapours can cause severe injury not only though contact with the body, but also if
the products are ingested or inhaled. It is imperative :
•
to know the material products and their risks,
•
notified or hazardous materials must be stored in accordance with the regulations,
•
the material must be stored in an appropriate container, never place materials in a container
where there is a risk o spillage or leakage,
•
a procedure must be applied for the safe disposal of waste material. It must comply with all
prevailing regulations and legislations of the country where the equipment is to be used,
•
protective clothing should always be worn in compliance with the material manufacturers'
recommendations,
•
depending on the application and chemical safety instructions, safety glasses, gloves, foot
wear, protective masks and possible breathing equipment should be worn to comply with the
regulations
(Refer to chapter "Safety equipment of KREMLIN selection guide).
CAUTION!
It is forbidden using any solvent or with halogenated hydrocarbon base and also products with these
solvents facing
aluminium
or
zinc
. The non-compliance with the instructions may cause explosion
hazards causing serious or fatal injuries.
EQUIPMENT REQUIREMENTS
PUMP
Before carrying out any work, it is imperative to get used with the compatibilities of motors with
pumps before coupling. The operator shall understand the equipment and the safety instructions.
These instructions are available in the manuals of the pumps.
F
A
The air motor is designed to be mounted with a pump. Never modify any components or couplings.
Where operating, please keep hands away from moving parts. Before starting up the equipment,
please read the PRESSURE RELIEF instructions. Please ensure that any relief or drain valves
fitted are in good working order.
