Choosing a Screw
Fine Thread
Because the smaller diameter and
thread pitch of our No.7 fine-thread
screws reduce the chance of splitting
the material, we recommend them for
hardwoods.
Deep square drive
improves driver
engagement
and reduces the
possibility of
cam-out.
Coarse Thread
Due to the large diameter and
thread pitch, our No.8 coarse-
thread screws offer a strong
hold in softwoods and composite
materials.
Self-Tapping
auger point
eliminates the
need to drill
a pilot hole.
Choosing a Screw
Note: Screw length is measured from bottom
of the head to the tip of the screw
32 mm [1¼
″]
Step 3: Select a Screw
Use this chart to select the correct screw length. Kreg
offers a complete line of pocket screws for every workpiece
thickness and type. All Kreg pocket screws are available at
your Kreg dealer or online at www.kregtool.com.
Screw Length Selection / Jig Setting Guide
Material
Thickness
Screw Length
Slider Setting
13 mm [½″]*
25 mm [1″]
13 mm [½″]
16 mm [⅝″]
25 mm [1″]
16 mm [⅝″]
19 mm [¾″]
32 mm [1¼″]
19 mm [¾″]
22 mm [⅞″]
38 mm [1½″]
22 mm [⅞″]
25 mm [1″]
38 mm [1½″]
25 mm [1″]
29 mm [1⅛″]
38 mm [1½″]
29 mm [1⅛″]
32 mm [1¼″]
51 mm [2″]
32 mm [1¼″]
35 mm [1⅜″]
51 mm [2″]
35 mm [1⅜″]
38 mm [1½″]
64 mm [2½″]
38 mm [1½″]
*Panhead pocket screw recommended.
Use in woods and composites such as:
• Pine • Cedar • Basswood • Poplar • Plywood • MDF • Particle Board
Use in woods such as:
• Ash • Oak • Maple • Walnut • Hickory • Cherry • Mahogany • Birch