11
Connect Jigs Together
Connect two or more jigs together for
longer drilling capability. Insert the top
of the second jig into the extension
connector at the bottom of the first jig.
Maintenance
Keep all parts clean of dust and debris.
Replace the drill bit when it is dull.
Care and Cleaning
To clean, wipe with a clean rag or blow compressed air on all parts.
To store, place all parts and hardware into the storage positions on the back of the jig.
Troubleshooting
Problem
Possible Cause
Solution
It is difficult to drill
the hole.
The drill is in reverse.
Check and reset the drill to forward.
It is difficult to drill
the hole.
The bit is dull.
Replace the bit.
There is excessive
tear out on holes.
The bit is dull.
Replace the bit.
The jig is not clamped
properly.
Check and clamp the jig properly.
The drill bit is started while it
is in contact with the wood.
Insert the drill bit into the drill guide
and bring the drill up to speed before
contacting the wood.
The side to side
alignment is off.
Not using the same
reference end.
Use the same reference end for both
sides of the cabinet.
Accessories
KMA3210 1/4" Shelf Pin Jig Drill Bit
KMA3215 5 mm Shelf Pin Jig Drill Bit
