I. Preparation Of Your Pool
Before assembling and installing your Kreepy Krauly, your pool should be clean and algae-free so as
not to inhibit the cleaner’s traction. If necessary, make the following preparations before proceeding:
1. Chemically balance the pool water.
2. Brush pool and let the debris settle.
3. Hand vacuum thoroughly.
4. Clean filter and pump strainer basket.
II. Assembly
Remove Kreepy Krauly and all of its parts from the box and check to make sure that all components
were included. Refer to Figure 1.
Components Check List
1. Dive float restrictor
2. Kreepy Krauly
3. Locking end clip
4. Roller bumper strap
5. Hose weights
6. Wings
7. Wing locking plates
8. Wing nuts and bolts
9. Eyeball diverter
10. Automatic regulator valve
10a. Cap
10b. Threaded compression adaptor
(1-1/2” and 2”)
11. Vacuum seal Flower
Step 1. Attach The Wings
The wings with hinges, locking plates, nuts
and bolts, are contained in a plastic bag. For
best results and ease of assembly, stand
your Kreepy Krauly at a 45˚ angle with the
upper body pointing away from you.
4
Figure 1
Locking Plate
Top Locking Plate
Off center holes
must face the
wing.
Bottom Locking Plate
off center holes face the
motor housing.
(Pre-assembled)
Hinge
Wing
Wing
3.
5.
6.
7.
8.
9.
11.
10a.
10.
10b.
1.
2.
4.
Figure 2
Figure 2A
Hold the wings in the up
position while tightening the
nuts and bolts. (Snug only.)
Flange
