KRAUSMANN 9727, Руководство по эксплуатации

Страница: 15 / 20

15
KRAUSMANN POWER TOOLS 9727
English | EN
The chamfer groove 6 allows you to cut a 45 o
chamfer on the edge of a workpiece. To cut a
chamfer, locate the edge to be cut in the chamfer
groove. Cut as usual, but hold the planer at 45 o .
Chamfering
5. Maintenance
Correct and regular cleaning will improve the safe-
ty and extend the lifespan of the device.
For safe and proper working, always keep the
tool and ventilation slots clean.
Τhe tool may be cleaned most effectively with
compressed dry air. Always wear safety goggles
when cleaning tools with compressed air.
Certain cleaning agents and solvents damage
plastic parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain
ammonia.
The brushes and commutator in your tool have
been engineered for many hours of dependable
service. To maintain peak efficiency of the motor,
we recommend every two to six months the
brushes be examined.
Store the tool, operating instructions and where
necessary the accessories in the original packag-
ing. In this way you will always have all the informa-
tion and parts ready to hand.
WARNING:
T urn the device off, disconnect it from the mains and wait
until it cools down before cleaning or maintenance to
avoid electric shock or burn.
Wear ear defenders
Wear safety goggles
Wear a dust mask
This tool has been checked by the manufacturer.
From the date of purchase by the final consumer,
a two year warranty for amateur use covers any
faulty material and manufacturing. The receipt or
invoice of purchase needs to be displayed in case
of a repair that is covered by the warranty. For pos-
sible faults during the warranty period, you should
address your issue to the retail shop from which
the purchase was made.
6. Warranty
The tool has been used properly and for the
purpose for which it was purchased.
The tool presents a problem that is due to
faulty material and manufacturing.
I ncapability of the tool to perform according
to the technical specs provided.
Damages are not covered by the warranty that are
due to causes such as:
Wear due to improper use.
Partial or total disassembly.The tool’s shell
must be disassembled only by personnel
authorised by the official distributor.
Damage due to overloading.
Usage of incorrect or incompatible accessory.
Bad maintenance from the operator or any
other third party.
Wear that was induced by external factors or
rogue particles (dust, debris etc.)
Wear due to non compliance with the instruc-
tions in this manual.
I f, during the warranty period, there is a fault that
can not be repaired from the authorised service
department, the tool will be replaced without any
extra cost.
Terms of warranty
The warranty is valid only when:
In case there is a need for a repair after the war-
ranty period has expired, we will provide the best
possible attention to repair the tool successfully.
7. Repair / Servicing