KRAUSMANN 9727, Руководство по эксплуатации

Страница: 13 / 20

13
KRAUSMANN POWER TOOLS 9727
Using the spanner supplied, loosen the three
clamp bolts securing the blade assembly, by
making a half-turn clockwise (approximately).
Holding the blade clamp in position, gently
slide the blade out of the blade clamp
through the slot in the tool housing. A piece
of wood or similar can be used to push the
blade smoothly. Do not remove the blade
clamp as this can change the factory settings
for the cutting depth adjustment. Also do not
adjust the height adjusting screws.
Reverse the blade or slide a new blade, in the
correct position, back into the blade clamp.
Check that the edge of the blade aligns with
the side of the sole plate.
English | EN
platform. Holding the workpiece by your
hand or against the body leaves it unstable
and may lead to loss of control.
Rags, cloth, cord, string and the like should
never be left around the work area.
Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
Use only sharp blades. Handle the blades
very carefully.
Be sure the blade installation bolts are
securely tightened before operation.
Before using the tool on an actual workpiece,
let it run for a while. Watch for vibration or
wobbling that could indicate poor installation
or a poorly balanced blade.
Make sure the blade is not contacting the
workpiece before the switch is turned on.
Wait until the blade attains full speed before
cutting.
Always switch off and wait for the blades
to come to a complete stop before any
adjusting.
Never stick your finger into the chip chute.
Chute may jam when cutting damp wood.
Clean out chips with a stick.
Do not leave the tool running. Operate the
tool only when hand-held.
Always change both blades or covers on the
drum, otherwise the resulting imbalance will
cause vibration and shorten tool life.
Use only blades specified in this manual.
SAVE THESE INSTRUCTIONS
WARNING:
M isuse or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
4. Functional description
and specifications
Intended use
This tool is intended for planing wood.
WARNING:
Always disconnect the plug from the power source before
making any adjustment or attaching any accessories. Do
not to use an abrasive wheels.
WARNING:
Take great care, and do not touch the cutting edge of the
blades.The blades fitted on the planer have two cutting
sides and are reversible.
Αssembly
Slide the dust bag 9 into the dust extraction port 8
before using the planer so that dust and waste are
collected safely. Do not use the planer without the
dust bag (or a vacuum system) fitted. For optimum
performance and through-flow of air, empty the
dust bag regularly and do not allow it to become
more than half full.
Fitting the dust bag
To reverse the blades or fit new blades:
Changing blades
Power supply
Power input
No load speed
Max. planning depth
Cable
Weight
Εργαλείο 9727
2 30 V ~ 50 Hz
710 W
17000 rpm
2 mm
2 m
2.75 kg