KRAUSMANN 8352, Руководство по эксплуатации

Страница: 17 / 20

17
KRAUSMANN POWER TOOLS 8352
English | EN
B
6
fig 6
Replacing the magnetic bit holder
If the magnetic bit holder becomes worn or
damaged, it must be replaced. The replacement
bit holder must be of the same dimensions as the
original and have the ANSI retention groove on the
end that is inserted into the tool.
NOTE:
U se only 1” (25 mm) long bits that are designed for use in
driving drywall screws. Make sure the bit size is correct for
the drywall screws being driven. This will usually be a #2
size.
i
Remove the nosepiece C by turning it count-
er clockwise (fig 7).
5
6
fig 5
Removing drywall screws
To remove drywall screws, remove the depth stop
6 to expose the screwdriver bit (fig 5).
The depth stop is a press fit onto the depth
adjustment sleeve 5 . Simply twist and pull outward
to slide it off the depth adjustment sleeve.
NOTE:
Y ou can also turn the depth adjustment sleeve clockwise
to expose the screwdriver bit. This however will cause you
to lose the depth setting and you will have to reset the
depth.
i
Inserting a screwdriver bit
This tool has a magnetic bit holder that provides
convenient bit changes. To install a bit, simply
insert the hex bit shank A into the bit holder B that
is located inside the depth stop 6 (fig 6). Push the
bit into the bit holder until the magnet holds the bit
in place.
5. Assembly
CAUTION:
A lways ensure that the tool is switched off and plug
is removed from the power point before making any
adjustments.
NOTE:
D o not use pliers on the nosepiece. Only use your hand.
i
G rasp the screwdriver bit A with pliers and
pull it out of the bit holder B .
G rasp the large end of the bit holder with
pliers and pull it straight out of the screw-
driver spindle D .
R everse the process by inserting the replace-
ment bit holder into the tool.
NOTE:
W hen inserting the replacement bit holder, gently tap it
into place to make sure it is fully inserted. Grasp the large
end of the bit holder to ensure the retention groove E is
holding the bit holder in place in the tool.
i
R einstall the screwdriver bit and nose piece
C .