KRAUSMANN 8352, Руководство по эксплуатации

Страница: 15 / 20

15
KRAUSMANN POWER TOOLS 8352
3
1
English | EN
4. Functional description
and specifications
WARNING:
I f the replacement of the supply cord is necessary, this has to
be done by a professional in order to avoid a safety hazard.
Intended use
The tool is intended for screw driving in drywall,
but also in wood, metal and plastic.
Power supply
Power input
No load speed
Maximum torque
Cable length
Weight 230V~50Hz
520W
0-4500 RPM
8 Nm
2m
1.45kg
Tool 8352
Variable Speed ON / OFF Trigger
Switch
This screwdriver is equipped with a
variable-speed ON / OFF trigger switch 1 (fig 1).
To start screwdriver, gently squeeze the ON / OFF
trigger switch. To stop the screwdriver, release the
ON / OFF trigger switch.
εικ 1 fig 1
condition leading to possible serious
injury. It will also void the warranty.
NOTE:
T he screwdriver will turn at its slowest speed when the ON
/ OFF trigger switch is depressed slightly. The screwdriver
will turn at its fastest speed when the ON / OFF trigger
switch is fully depressed.
i
Forward/Reverse Control
ON / OFF Trigger switch lock
The forward / reverse switch 3 is conveniently
mounted in front of the trigger switch 1 (fig 2). To
make the screwdriver rotate clockwise for driving
screws, push the forward / reverse switch to the
left. To make the screwdriver rotate counter-
clockwise to remove screws, push the forward /
reverse switch to the right.
Ιf you press the lock-on button 2 while the ON /
OFF trigger switch 1 is depressed at full speed,
the tool is kept in the operating position (fig 2).
This is convenient when continuous operating for
extended periods of time is required. To release
the lock on button, press and release the ON / OFF
trigger switch.
WARNING:
Never change the position of the forward / reverse switch
while the screwdriver bit is turning. The trigger switch
will NOT function with the forward / reverse switch in the
middle position.
2
3
fig 2
Adjusting the screw driving depth
It is important to control the depth to which the
drywall screw will be driven. Over driving the screw
will drive the screw too deep and break the outer
paper layer of the drywall. Under driving the screw
will leave the screw head above the drywall surface
making it impossible to properly finish the drywall.
NOTE:
Operating the screwdriver with the trigger switch ON for
an extended period of time may cause the screwdriver
motor to overheat. If the screwdriver gets hot, stop
driving screws and allow it to cool for at least 15 minutes.
i