12
17
Preparation for use
When using cleansing agents:
For this machine a screwed-in injector no. 1 for inducting cleansing-agents is
available as special accessories.
(Screwed-in injector order no. 13.376 2).
Place chemical filter no. 2 in the reservoir with the cleansing agent. Push Vario-
Jet no. 3 to front position to enable th injector to induct the cleansing agent. By
sliding back the Vario-Jet nozzle, the supply of chemical is automatically cut off.
Allow the cleansing agent to take effect and then remove with high pressure
spray.
Car cleaning, glass, caravan, boat etc.: rotary
washing brush with 40 cm extension and
ST 30 nipple M 22
Underbody cleaning of cars, trailers and
equipment: lance 90 cm with high pressure
nozzle and ST 30 nipple. The lance must be
aimed when spraying.
Cleaning cars and all smooth surfaces: brush
with ST 30 nipple M 22.
Rotary point sprayer for extreme soiling: dirt
killer with 40 cm extension and
ST 30 nipple M 22.
To shut down the pump:
1. Switch off the machine.
2. Cut off the water supply.
3. Open the spray gun briefly until the pressure is released.
4. Apply the safety catch on the spray gun.
5. Remove the water hose and high pressure hose.
6. Drain the pump: switch on the motor for approxx 20 sec. .
7. Pull the plug from the socket.
8. Winter: store the pump in rooms above 0
°
C.
9. Clean the water filter.
1
3
2
Note that you must always
comply with the instuctions
provided by the manu-
facturer of the cleansing
agent (e.g. instructions
concerning safety clothing)
and the water protection
regulations.
for further combination possibilities
