WP-DEC7
Quick Start
P/N:
2 9 0 0 - 3 0 1 5 8 2 QS
Rev:
3
Scan for full manual
WP-DEC7 Quick Start Guide
This guide helps you install and use your
WP-DEC7
for the first time.
www.kramerav.com/downloads/WP-DEC7
to download the latest user manual and check if firmware
upgrades are available.
Step 1:
Check what’s in the box
WP-DEC7
4K AVoIP Decoder
Frame (or frame set) and faceplate
Installation accessories
1 Quick start guide
Step 2: Get to know your WP-DEC7
#
Feature
Function
1
HDMI OUT
Connector
Connect to an HDMI acceptor.
2
HDMI LED
Lights Green
A link has been established with an encoder which is transmitting A/V
signals.
Flashes Green
A signal is established, and a problem is detected.
3
ON LED
Flashes Red
On fallback address acquiring, device ‘ON’ LED flashes continuously
in slow 0.5/10sec cadence.
Lights Green
When power is on.
Flashes Green slowly
Device is in standby mode.
Flashes Green fast
FW is downloaded in the background.
Flashes Green very fast (for 60sec) A device identification command is sent (Flag me).
Lights Yellow
Device falls back to default IP address.
Lights Red
Security is blocking IP access.
4
CH+ / CH-
Click the recessed CH buttons to configure the channel ID. The channel ID will show in the LCD display.
On the US model, access to these buttons requires removal of the frame.
5
RESET
Press and hold for 10 seconds to reset the device to its factory default values. All LEDs flash.
On the US model, access to this button requires removal of the frame.
6
Display Panel Shows the number of the ethernet channel on which the device is receiving the signal.