10
WP-501 - Using Your WP-501
3. On the rear panel, connect the display device (for example, a projector) as
follows. Connect the:
VGA (PC) OUTPUT to the PC Graphics (15-pin HD connector or
RGBHV connector) input on the projector
VIDEO OUT output (VIDEO OUT, GND) to the video input on the
projector
AUDIO OUT 1 and AUDIO OUT 2 outputs to the audio input of the video
and PC inputs on the projector
You can connect either AUDIO OUT 1 or AUDIO OUT 2 to either the PC or the
CV input of the projector since both audio outputs are identical
RS-232 port to the PC control port of the projector and/or the IR OUT to
the IR receiver of the projector
4. Connect the relay terminal block connectors to the screen.
5. Connect the ETHERNET port to a PC for configuration and control (not
shown in
Figure 6
), see
Section 5.3
.
Figure 6: Connecting the WP-501 Rear Panel
