Step 6: Operate via the Web pages:
Route video and audio signals
:
Click a white button in the matrix to route an input to an output (audio and/or video).
Optional input to output routing.
Video only is routed.
An active signal is detected (for inputs and outputs).
Current input to output routing state.
Audio only is routed.
No active signal is detected (for inputs and outputs).
Additional functions
:
Inputs
:
HDMI and HDBT
Click the input name to change its settings.
Click to route the audio and video inputs separately.
Click to toggle between the HDBT and HDMI input.
Analog Audio
Click the input name to change its settings.
Click
to change audio level settings.
Click to toggle between one analog input signal and two mic. Input signals.
Outputs
:
HDMI and HDBT
Click the output name to change its settings.
/
Audio-only mode is enabled/disabled.
/
HDMI is on/off.
/
Audio-follow-video mode is enabled/disabled.
/
AUDIO is on/off.
/
Pattern is selected/not selected.
Analog and Amplified Audio:
Click
to change audio settings.
Default communication parameters
:
RS-232
Protocol 3000
Baud Rate:
115,200
Stop Bits:
1
Data Bits:
8
Parity:
None
Example (Set the volume on analog audio input 5 to 10dB):
#X-AUD-LVL IN.ANALOG_AUDIO.5.AUDIO.1,10
TCP/IP Parameters
IP Address:
192.168.1.39
UDP Port #:
50000
Subnet mask:
255.255.000.000
Maximum UDP Connections:
Unlimited
Default gateway:
192.168.0.1
Maximum TCP Connections:
Unlimited
TCP Port #:
5000
Full Factory Reset
Protocol 3000
Use
“
#FACTORY
” command
and use “
#RESET
” to restore the factory default values.