KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VS-44HC
8
6 Connecting the VS-44HC
This section describes how to connect the
VS-44HC
. In particular, how to:
Connect the
VS-44HC
rear panel (see section 6.1)
Connect the audio signals (see section 6.2)
Set the dipswitches (see section 6.3)
6.1 Connecting the VS-44HC Rear Panel
To connect the
VS-44HC
, as the example in Figure 3 illustrates, do the
following
1
:
1. Connect up to four component video sources
2
(for example, four DVD
players) to the three IN RCA connectors Y, Pb/Cb and Pr/Cr (from IN 1
to IN 4) and connect the corresponding digital audio sources to the
S/PDIF
3
RCA connectors (see section 6.2).
2. Connect
4
the four sets of three OUT RCA connectors Y, Pb/Cb and
Pr/Cr (from OUT 1 to OUT 4) to up to four video acceptors (for
example, four plasma displays), and connect the corresponding S/PDIF
5
RCA connectors to the four digital audio acceptors
6
(see section 6.2)
3. Set the dipswitches (see section 6.3).
4. If required, connect a PC and/or controller to the RS-232 port (see
section 7.1) and/or the RS-485 port (see section 7.2) and/or the
ETHERNET port (see section 7.3).
5. Connect the power cord
7
(not shown in Figure 3).
1 Switch OFF the power on each device before connecting it to your VS-44HC. After connecting your VS-44HC, switch on
its power and then switch on the power on each device. DO NOT push in the rear panel Flash Program “Flash Upgr.” button
(see Table 3) and DO NOT switch the ETH Flash switch. These are only used for upgrading to the latest Kramer firmware
(see section 9)
2 Although in this example four inputs are connected, you can connect less inputs
3 Or TOSLINK connector for IN 2
4 When less than four outputs are required, connect only those outputs of the VS-44HC that are required, and leave the other
outputs unconnected
5 Or TOSLINK connector for OUT 2
6 For example, an AV receiver or the audio connector of the plasma display
7 We recommend that you use only the power cord that is supplied with this machine
